BTD 800 USB

ARTICLE NO. 504579

 

The BTD 800 USB dongle is used in combination with PRESENCE™ UC or MB Pro headsets to provide a solution that is compatible with leading United Communications platforms such as Cisco, Avaya and IBM.

For instructions on pairing the BTD 800 with PRESENCE™, click here.

For instructions on pairing the BTD 800 with MB Pro, click here

For instructions on pairing the BTD 800 with MB 660, click here

 

 

How to perform a factory reset

  1. Place the dongle into pairing mode (press the button once). LED should begin to flash alternately red and blue.
  2. Press the button twice in rapid succession ('double tap'). LED should now flash purple three times. These flashes are very quick and may be missed if attention is not paid.
  3. The dongle will now undergo a reset and all pairing history will be deleted. The device should then re-enter pairing mode.

Please note that once a factory reset has been performed, another cannot be done until the dongle has been paired again with at least one device.

 

 

 

Please find attached a copy of the quick guide for the BTD 800 USB.

Was this article helpful?
0 out of 0 found this helpful