Pairing the Presence

Whenever pairing a headset, the first step is to place the headset into pairing mode. Once the headset is in pairing mode, you will need to follow the pairing steps for the end-device you wish to connect the headset to. 

 

 

 

Placing the Presence into pairing mode

To place the Presence into pairing mode, first ensure the headset is off. 

Next, press and hold the multifunction button as you pull the power slide out to switch the headset on, until you hear the voice prompt "pairing". 

The LED on the headset should now be alternately flashing red and blue, indicating that your Presence has successfully been placed into pairing mode.

 

 

Pairing the headset with a smartphone or other Bluetooth enabled device

Once you have confirmed that the headset is in pairing mode, you will need to complete the pairing process on the end-device you wish to connect to. 

Within the device's menu, ensure that Bluetooth is enabled and then search for new Bluetooth devices. You should then be able to see all active devices in your vicinity. 

Find and select your Presence. You may be prompted to enter a PIN - if this is the case, enter the default Sennheiser PIN "0000".

When pairing is successful, the LED on the headset will flash blue three times. If the LED instead flashes red three times, pairing has failed and the process should be repeated. 

 

 

Pairing the headset with the BTD 800 dongle 

Once you have confirmed that the headset is in pairing mode, you will need to place the dongle itself into pairing mode as well. 

To do so, ensure that the dongle is inserted and then press and hold the button for approximately three seconds, or until the LED begins to alternately flash red and blue. 

After placing both devices into pairing mode, they should then pair with one another. When pairing is successful, the LED on both the headset and the dongle will flash blue three times. If the LED flashes red three times, pairing has failed and the process should be repeated. 

Was this article helpful?
0 out of 0 found this helpful